Nutrient Recommendations

A blue tractor spraying / applying nutrients to a field.

Nutrient Recommendations

 

Nutrient recommendations are based upon soil test calibration studies that relate the probability of a profitable plant response to nutrient addition to the plant nutrient concentration in the soil as measured by a soil test.

Review the "Using the nutrient recommendations" below and then select an crop type to view a PDF with individual recommendations.

USING THE NUTRIENT RECOMMENDATIONS

 

Converting from Soil Test Results to University of Delaware Fertility Index Value (FIV)


Nutrient recommendations are based upon soil test calibration studies that relate the probability of a profitable plant response to nutrient addition to the plant nutrient concentration in the soil as measured by a soil test. However, the concentration of a soil nutrient measured by a specific soil test extracting solution is a function of the chemical composition of extracting agent and the forms of the nutrient present in the soil. Consequently, the concentration of a plant nutrient measured on a soil sample will vary with the soil test extracting solution used.

University of Delaware Nutrient Recommendations are based on the Mehlich 3 soil test. The University of Delaware Soil Testing Program reports results for phosphorus (P), potassium (K), calcium (Ca), and magnesium (Mg) as a Fertility Index Value (FIV). Results for manganese (Mn), zinc (Zn), sulfur (S), and boron (B) are reported in pounds per acre (lb/ac). Other regional soil testing laboratories may use different soil test extractions or report results in different units (Table 1).

 

Table 1. The most common soil tests used by laboratories that analyze samples from Delaware and the Delmarva Peninsula.
Laboratory Soil Test Method Reporting Units
University of Delaware (UD) Mehlich 3 UD-FIV (P, K, Mg, Ca), lb/ac (Mn, Zn, S, B)
AgroLab Mehlich 3 ppm, UD-FIV (for P only)
Brookside Laboratories, Inc Mehlich 3
Bray 1 P
Ammonium acetate K
ppm
Penn State University Mehlich 3 ppm
Rutgers University Mehlich 3 lb/ac or ppm
Spectrum Analytical Laboratories Mehlich 3 lb/ac or ppm
Virginia Tech Mehlich 1 lb/ac
Waters Agriculture Laboratories, Inc Mehlich 1 lb/ac
Waypoint Analytical Mehlich 3
Mehlich 1
Bray 1 P
Ammonium acetate K
ppm

 

If available soil test results were obtained from a soil testing laboratory that uses a soil extract other than Mehlich 3 or that reports Mehlich 3 results in units other than UD-FIV (P, K, Ca, Mg ) or lb/ac (Mn, Zn, S, B), it is necessary to first convert those soil test values to the equivalent UD-FIV or Mehlich 3 equivalent in lb/ac before making a nutrient recommendation.

NOTE: Nutrient recommendations prepared using the University of Delaware Nutrient Recommendations from soil test results that were not properly converted to UD-FIV or Mehlich 3 (lb/ac) may be completely inaccurate. Inaccurate recommendations could result in under- or over-application of the required nutrient and subsequent loss of yield or unnecessary expense.

Conversion factors are available based on correlation studies between Mehlich 3 and the other extracts using 300 Delaware soil samples) in the following tables. NOTE: Some laboratories offer multiple extractants (e.g., Brookside, Waypoint). Confirm which soil test extractant was used with the soil testing laboratory before selecting a conversion table.

 

Calculating the Lime Recommendation

To determine the lime requirement for a field, follow these steps:

Select the appropriate lime table from the list below based upon the target pH of the crop as listed in the recommendation section.  Locate the value in the table where the Water pH row (shown along the left side of table) and the Buffer pH column (shown across the top of the table) intersect (see example).

Determine whether a lime credit is necessary. Lime credits are used to account for any lime that was applied in the past 18 months which has not had a chance to react. The equation for calculating the lime credit and an example can be obtained by clicking here.

Determine the the type of lime recommended (e.g., calcitic or dolimitic) by clicking here.

 

Writing a Lime Recommendation

Step-by-step instructions for writing a lime recommendation is available in Calculating the Lime Recommendation Using the Adams-Evans Soil Buffer.  If the lime requirement test was performed by laboratory using a different buffer pH method (Table 2), refer to Measurement and Management of Soil pH for Crop Production in Delaware.
 

Table 2. Methods for water and buffer pH tests used by regional soil testing laboratories.
Laboratory Soil pH Method Lime Requirement Method
University of Delaware (UD) Water (1:1) Adams-Evans
AgroLab Water (1:1) SMP
Brookside Laboratories, Inc Water (1:1) SMP/Sikora
Penn State University Water (1:1) Mehlich
Rutgers University Water (1:1) Adams-Evans
Spectrum Analytical Laboratories Water (1:1) Sikora
Virginia Tech Water (1:1) Mehlich
Waters Agriculture Laboratories, Inc Water (1:1) Adams-Evans (KY location); Mehlich (NC location)
Waypoint Analytical Water (1:1) Mehlich; SMP (by request only)

 

 

University of Delaware Lime Tables

These tables are designed to be used with the Adams-Evans buffer pH. If the lime requirement test was performed by laboratory using a different buffer method, contact the laboratory for the appropriate lime tables.

 

Commercial Agriculture Soil Test Notes