UpDate - Vol. 11, No. 6, Page 7
October 10, 1991
UDInfo making the connection

DIAL-IN
     1.   Configure your modem and communications software as
          follows: No Parity; Eight Data Bits; One Stop Bit, Full
          Duplex (Local Echo Off).
     2.   For 300/1200/2400 bps service, dial 6150.
     3.   Press the ENTER key until you receive the UDELNET
          greeting message.
     4.   Type: UDInfo and press the ENTER key once or twice until
          you are asked for your terminal type.
     5.   In response to the message "ENTER terminal type," type
          the code for your terminal and press the ENTER key.
          Terminal types include: VT100, IBMPC, Z19, Z29, HP2621,
          IBM3101 and TYPETERM. If you are not sure, select
          VT100.
     6.   You are now connected to UDInfo, press ENTER to begin.
     7.   To sign off, type the letter "o" and press ENTER.

TELNET
     1.   Use your Telnet software to attach to the campus network
          or Internet.
     2.   Telnet to UDInfo using the following command: telnet
          udinfo. If you access the network from an off-campus
          Internet location, enter: telnet udinfo.udel.edu
     3.   Press the ENTER key once or twice until you see the
          prompt for your terminal type.
     4.   In response to the message "ENTER terminal type," type
          the code for your terminal (see step 5 above).
     5.   You are now connected to UDInfo, press ENTER to begin.
     6.   To sign off, type the letter "o" and press ENTER.

MVS
     1.   Select UDInfo from the Application Selection Menu after
          you log on to MVS.
     2.   To sign off, type the letter "o" and press ENTER.